Hey there.... so, I have had an issue probably many of you know. The small exit pipe of the tube was so short that the pee did fow pver the belt and made it rust at some welding points at the spot where the back part is attached. That's why I bought a short pvc rubner pipe to shick over the tube exit. Well, gluing it with superglue did work for some time, but after the second night it broke off... Why? Because it's obviously difficult. To make a proper gluing at this short part with both materials under the condissiols that it's be stressed often and both materials have a different expension under body heat... also because when mooving the rubner pipe there's a lot of force on the tiny glued part...
That's why I glued it again. Short before the glue got dry I got a good idea. The conntection is of course way too short to use a normal pipe connection (Schlauchschelle), so I took a oil output islosation ring of a Mercedes C Klass (had it left over in my basement workststion) ... it has the ideal measures ... so i pressed it ocer and used a hammer and smashed it slightly on a second one with was obvioulsy the ocer way round... that way I could adopt the straight copper-ring to the bowed steel of the belt. see here
If it doesn't hold, I'll get another copper ring and use a 2 component epoxy based glue which should work better, of course
